Top
Car ESC

Lightning

Smooth start, sensitive control;

Low resistance circuit design, less heat generation.


Buy now
PRODUCT FEATURES

img-1.jpgimg-2.jpgimg-3-.jpg

SPECIFICATION
Model
Battery
Con. Current
Burst Current(10S)
BEC
Weight
Size
Firmware
Typical Applications
Product features
Lightning-18A
Lightning-25A
Lightning-35A
Lightning-45A
2-3s
2-3s
2-3s
2-3s
18A
25A
35A
45A
50A
90A
190A
260A
6V/2A or 6V/1A
6V/2A or 6V/1A
6V/2A or 6V/1A
6V/2A or 6V/1A
40g
42g
46g
54g
34×29×19mm
34×29×19mm
34×29×19mm
34×29×31mm
-
-
-
-
1:18/1:16
1:18/1:16
1:18/1:16
1:10

● Well-designed driver firmware for RC vehicles, smooth throttle response.

● ESC is compatible with sensorless brushless motor and sensored brushless motor,

● 9 levels of start acceleration for different vehicles, tires and tracks.

● 8 timings can be selected , it can motors can work at the best efficiency point.

● Proportional brake with 6 levels of maximum brake force and 8 levels of drag brake force.

● Perfect protections: low voltage protection, thermal protection, throttle signal loss protection and motor stall protection.

● Highly reliable electronic switch avoids troubles which may happen to traditional mechanical switch due to dirt,dash,water and etc.

● ESC programming or restore the default values via the Power/PRG button on the ESC.

● ESC programming also can use the program box(item sold separately).

TECHNICAL SUPPORT
车模编程卡TECHNICAL SUPPORT
对车模电调进行设置,用编程卡对电调进行设置是最理想和方便的选择,只要将电调信号线插入编程卡对应的(+ - )接口,(注意:未带BEC输出的电调,请在“+ -”加入5VDC),按下【ITEM】按键选择想要更改的项目,按下【VALE】按键选择该项目的参数值,按下【OK】VALUE窗口显示“S”表示该参数值设置完毕。恢复出厂默认选项先按【RESET】,再按【OK】即可。
Immediate purchase
Troubleshooting
1. The car goes backward when the controller sends go forward instruction.
1. The connection of the cables which connecting to the motors should be reversed. 2. The steering system of the car differs to regular steering systems.
2. The motor suddenly stops while it's running
1. Check if the receiver is interfered and check the remain power of the battery. 2. Replace a new battery if the battery voltage is too low. 3. It can be over-heat protection is triggered. Wait a few minutes to have the ESC cooled off.
3. The motor is rapidly accelerated while the power is on, or the motor is jammed or lagged.
1. Replace battery with stronger discharge ability.2. Replace lower speed motor to increase reduction ratio. 3. Set the start mode to lower level.
4. The motor is vibrating but not started.
1. Check all the connections; 2. Check all soldering points; 3. Contact FLYCOLOR to repair.

If you have any ideas or Suggestions about our products, please let us know